RSP Wax Kit
RSP Hot Melt Wax 400g
Only the highest quality ones are used in our HOT MELT CHAIN WAX
Additives used:
Such as tungsten sulfide (WS2). Tungsten sulfide has one
incredibly low coefficient of friction 0.03 - better than
Molybdenum, PTFE or even wet ice on wet ice!
Increases power transmission and reduces wear.
Very low friction - works over a wide area
Temperature range from -270 °C to +650 °C
Biodegradable / Biodegradable
(OECD TEST 301 B)
For up to 40 applications
R.S.P. Wax melting furnace AX 700 for chain wax. (Hot Melt Wax)
Capacity: 500ml
Voltage: 220-250V
Frequency: 50/60Hz
The melting furnace is ideal for all types of chain waxes. It melts any type of wax, including wax beads and wax blocks. Capacity: 500 ml Voltage: 220-250 V Frequency: 50/60 HzT Power: 120 watts Temperature range: 0-120°C Aluminum inner container How to get the device ready for use: 1. Connect the device to the power supply. 2. Remove plastic lid from warmer. Add wax from the can or drops of wax into the warmer. 3. Turn on the heater, set the temperature unit (°C or °F) and adjust the temperature until the wax melts. This process takes about 15 minutes. To speed it up, close the warmer with a lid. The higher the temperature of the wax, the faster it melts. 4. Once the wax has melted, reduce the temperature, 5. It is important to check the temperature of the wax before application and adjust if necessary. The wax should not be too hot or too cold. 6. Continue treating the chain. 7. After completing the treatment, remove the wax can from the device, switch off the device and then cover it with the lid. 8. If you clean the device with a special agent after disconnecting it from the power supply when it is still slightly warm. Caution ! The inner container and wax are hot after melting! Risk of burns.
BRAKE SHAKE (brake cleaner)
Brake Shake is your powerful cleaner for brakes and brake discs
and rims. This will remove oils, fats and even stubborn ones
Get rid of dirt again.
Brake Shake puts an end to annoying squeaking brakes. The brake pads
can remain mounted when sprayed with Brake Shake.
Here's how it works: Spray Brake Shake generously on your
mounted brake system and rims.
The dissolved dirt simply drips off.
